Plesk 12 and Atomic Basic ModSecurity rule set

General Discussion of atomic repo and development projects.

Ask for help here with anything else not covered by other forums.
pinguina
New Forum User
New Forum User
Posts: 2
Joined: Fri Oct 03, 2014 12:14 am
Location: Managua

Plesk 12 and Atomic Basic ModSecurity rule set

Unread post by pinguina »

Hi there,
I have Parallels Plesk 12.0.18 with CentOS 6.5 (Final)

WAF is On, with Atomic Basic ModSecurity rule set.

I was wondering if my sites were protected and I went to the Atomic wiki.

When I run a test from a non-whitelisted system following these instructions (STEP 10) https://www.atomicorp.com/wiki/index.ph ... web_server
I always receive 404 error.

Is there any other way to check if WAF is protecting my server with Plesk 12?

Thanks in advance.

P.
scott
Atomicorp Staff - Site Admin
Atomicorp Staff - Site Admin
Posts: 8355
Joined: Wed Dec 31, 1969 8:00 pm
Location: earth
Contact:

Re: Plesk 12 and Atomic Basic ModSecurity rule set

Unread post by scott »

you'd need to ask parallels about this, we made the ruleset available to them, but they implemented it using their own design. They might not be using 403 error codes like we do.
pinguina
New Forum User
New Forum User
Posts: 2
Joined: Fri Oct 03, 2014 12:14 am
Location: Managua

Re: Plesk 12 and Atomic Basic ModSecurity rule set

Unread post by pinguina »

Thanks Scott, Im gonna ask them.
In the meantime Im gonna test ASL.
I hope it works without issues with Plesk 12

P.
User avatar
mikeshinn
Atomicorp Staff - Site Admin
Atomicorp Staff - Site Admin
Posts: 4149
Joined: Thu Feb 07, 2008 7:49 pm
Location: Chantilly, VA

Re: Plesk 12 and Atomic Basic ModSecurity rule set

Unread post by mikeshinn »

ASL is fully supported with Plesk 12. We use Plesk 12.
Post Reply