ASL config via GUI gone read-only?

faris · Unread post by **faris** » Wed Jul 08, 2015 3:55 pm

I just updated aum and asl and noticed that I can't seem to change the config via the GUI - I get values but no option to change anything.

I don't know if it is related, but there's this in the error log:

Code: Select all

2	2	ASLWCL::clientapi_get	An error occurred attempting to read file /etc/asl/cl_clientapi
Check ownership and permissions

racerx8413 · Unread post by **racerx8413** » Thu Jul 09, 2015 9:25 am

Same issue, as of this morning the gui is read only on at least 3 of our boxes I've checked this morning, I'm going to assume all that were updated yesterday.

Unread post by **mikeshinn** » Thu Jul 09, 2015 2:08 pm

We see what causes this on some platforms and just put out an update. Just run:

aum -uf

And log out of the console and back in to refresh your permissions.

To make sure youre running 4.0.12-26 and that should fix this for you.

faris · Unread post by **faris** » Thu Jul 09, 2015 2:37 pm

aum -uf didn't actually update the aum, asl and asl-* packages. Is it supposed to do so?

Manually updating them to -26 resolved the problem. Thanks!

Atomicorp

ASL config via GUI gone read-only?

ASL config via GUI gone read-only?

Re: ASL config via GUI gone read-only?

Re: ASL config via GUI gone read-only?

Re: ASL config via GUI gone read-only?