Quota not working centos 5

[aus-city]

New install, centos 5 plesk 10.1

It's got usrquota set on VolGroup00 in fstab.

You can run check quota and quota off and on, all works.

Plesk says its not supported by OS.

How can I fix it?

I did a quota dump and it shows all the users and usage it's nuts!

[nobody]

go to your fstab and lines after default should look like the example below :

/dev/md0 / ext3 defaults,usrquota 1 1

then reboot

hope this helps.

regards

[aus-city]

Thanks!

It was already there.

Turned out to be plesk, I just installed something in the CP and it ran quotacheck now it works.

[breun]

The Plesk knowledge base article on quota is here: http://kb.parallels.com/768

I also remember having to run that quotacheck command mentioned there in some cases.