Installer Script - selecting the Client option
Posted: Wed Jun 04, 2014 6:25 am
Hello all,
Not sure if this a bug or I have missed something. Set up is
New Central server, ASL 4.0.2-12 installed on CentOS 6, yum Upgrade and all updated and everything is good
new Satellite server built, Centos and Virtulamin installed and then repos disabled. yum upgrade not done yet, as I normal put ASL on first, then upgrade.
When you run the installer script, and get to the server/client question, and type client, and hit enter, the installer script jumps back to the start.
I haven't had time to look at the script, but just wondering if anyone else had seen this issue before I report it as a bug, or before I embarrass my self by reporting a bug which is in fact my overlooking the obvious.
Regards
Adstock
Not sure if this a bug or I have missed something. Set up is
New Central server, ASL 4.0.2-12 installed on CentOS 6, yum Upgrade and all updated and everything is good
new Satellite server built, Centos and Virtulamin installed and then repos disabled. yum upgrade not done yet, as I normal put ASL on first, then upgrade.
When you run the installer script, and get to the server/client question, and type client, and hit enter, the installer script jumps back to the start.
I haven't had time to look at the script, but just wondering if anyone else had seen this issue before I report it as a bug, or before I embarrass my self by reporting a bug which is in fact my overlooking the obvious.
Regards
Adstock